Assembly Instruction

ManualsBrandsPottery Barn ManualsBedroomPottery Barn Devon Twin Full Bed

pottery barn kids

DEVON BED

CAUTION

: Adult assembly required. This item contains small parts that have sharp points and edges in the

unassembled state. Adults should take care when unpacking and assembling this item.

PRE-ASSEMBLY:

• Please read all instructions before beginning assembly.

• For ease of assembly two people are recommended.

• Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or

hardware. One extra drawer knob is included for your convenience.

• Use caution when using power tools to aid in assembly. Power tools can split wood or strip hardware

if not used carefully.

PARTS INCLUDED:

(A) Right Unit – 1pc

(A-1) Feet – 4pcs

(B) Left Unit – 1pc

(B-1) Feet

– 4pcs

(C-1) Front Panel – 1pc

(C-2) Center shelf – 1pc

(C-3) Back Panel – 1pc

(D) Side Rails and Slats

– 2pcs

(E) Footboard

– 1pc

(E-1) Feet – 2pcs

(E-2) Headboard panel – 1pc

(E-3) Slat – 1pc

(F-4)

Finial

– 2pcs

(F) 3 Drawer Component

– 1pc

HARDWARE ENCLOSED:

(G) Allen Key – 1pc

(H) 5/16” x 30mm Allen Bolt

– 16pcs

(I) 5/16” Spring Washer

– 16pcs

(J) 5/16” Flat Washer – 16pcs

(K) Wood Screws 5/32” x 30mm – 40pcs

Summary of content (4 pages)

PAGE 1
pottery barn kids DEVON BED CAUTION: Adult assembly required. This item contains small parts that have sharp points and edges in the unassembled state. Adults should take care when unpacking and assembling this item. PRE-ASSEMBLY: • • • • Please read all instructions before beginning assembly. For ease of assembly two people are recommended. Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
PAGE 2
ASSEMBLY INSTRUCTIONS: 1. Carefully lower Right Unit (A) and Left Unit (B) on a soft, scratch-free surface. Thread the 4 feet (A-1 and B-1) into pre-drilled holes in the bottom of Right Unit and Left Unit, as shown. Carefully raise both units upright. (Fig. 1) A-1 & B-1 2. Carefully insert the Front panel (C-1) into the Right & Left Units as shown, fastening the connections using Allen Bolts, Flat Washers, and Spring Washers. Hook the Headboard panel (E-2) into the Left Unit. (Fig.
PAGE 3
. Carefully place the Center Shelf (C-2) between the 4. Carefully place the Center Top panel (C) on the top Right & Left Units as shown, and connect using Allen of Right & Left Units as shown, and fasten using Wood Bolts, Flat Washers, and Spring Washers to secure the Screw (K), Flat Washers, and Spring Washers. (Fig. 5) center unit. Slide the Back Panel (C-3) into the slots. (Fig. 4) (Fig. 4) C-3 (Fig. 5) C C-2 5.
PAGE 4
7. Carefully place the 3 Drawer Unit (F) on the side of the side rail as shown. (Fig. 8) 8. Place Slat roll (E-3) on the side rails, using the stoppers on the end of ledge to prevent slat roll from moving. Secure slats with the remaining Wood screws (K) using a Phillips screwdriver. (Fig. 9) (Fig. 8) (Fig. 9) F Thank you for your purchase stores | catalog | www.potterybarnkids.com 1.800.290.