Assembly Instruction

pottery barn kids

CAMERON WALL SYSTEM NARROW BASE

IMPORTANT SAFETY INSTRUCTIONS:

Please read all instructions carefully before assembling.

For your safety, assembly by two adults is recommended.

PRE-ASSEMBLY:

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work

surface, as this will avoid damaging any parts during assembly. The shipping box provides an ideal work

surface. Do not dispose of any contents until assembly is completed to avoid accidentally discarding small

parts or hardware.

• Use the parts and hardware lists above to identify and separate each of the pieces included.

• The illustrations provided allow for easier assembly when used in conjunction with the assembly

instructions.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may

cause the bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split

wood.

ASSEMBLY INSTRUCTIONS:

1. Align and insert the pre-drilled holes on the Left/Right Side Panels (C&D) to the wooden dowels on the

Bottom Piece (B). Make sure the slots on the Left/Right Side Panels (C&D) are facing each other. (Fig.

1) ). Secure from the underside of the Bottom Panel (B) with (4) Flat Washers (I), Spring Washers (H)

and Bolts (G). Loosely tighten using the Allen Key (F).

(Fig. 1)

(Fig. 2)

PARTS INCLUDED:

(A) Top Panel – 1pc

(B) Bottom Piece – 1pc

(D) Right Side Panel – 1pc

(E) Back Panel – 1pc

HARDWARE INCLUDED:

(F) Allen Key

- 1pc

(G) Bolt ¼“ x 28mm

- 8pcs

(H) Spring Washer ¼“

- 8pcs

(

)

Flat Washer ¼” - 8

PAGE 1
pottery barn kids CAMERON WALL SYSTEM NARROW BASE IMPORTANT SAFETY INSTRUCTIONS: Please read all instructions carefully before assembling. For your safety, assembly by two adults is recommended.
PAGE 2
. Slide the Back Panel (E) into the slots on the Left/Right Side Panels (C&D) on the assembled piece. (Fig. 2) (Fig. 2) 3. Place the Top Panel (A) on the assembled piece. Align and insert wooden dowels on the Left/Right Side Panels into the pre-drilled holes on the Top Panel (A). Secure from the underside of the Top Panel (A) with (4) Flat Washers (I), Spring Washers (H) and Bolts (G). Loosely tighten using the Allen Key (F). (Fig.3) (Fig. 3) 4. Check alignments and fully tighten all bolts.