Assembly Instruction

Page 3/4
4. Insert (4) Plastic Cap (L) into the pre-drilled holes on the Bottom Panel (D) and Top Panel (E). Place the
Top Panel (E) on the assembled piece. Lift the Top Panel slightly to allow the Left/Right X/O Doors (T&U,
sold separately) to fit into the Plastic Caps (L) on Bottom Panel and Top Panel. Check alignment and
secure the Top Panel with the remaining (4) Allen Bolt (H), Spring Washer (I) & Flat Washer (J).
5. Then, Secure the Back Panel (C) to the Top Panel (E) from inside the cubby using (2) Long Wood Screw
(K). (Fig. 4)
Figure 4
T
E
L
L
U
K