Assembly Instruction

3. Place the Top Panel (A) on the assembled piece. Insert (4) Bolt (K), Spring Washer (L) and Flat Washer
(M) from the pre-drilled holes on the Left/Right Side Panels (C & D) to the pre-drilled holes on the Top
Panel (A). (Fig. 3)
4. Slide the Back Panel (F) into the slots on the Left/Right Side Panel (C & D). (Fig. 4)
F.
(Fig. 4)
A.
J.
K.
L.
M.
(Fig. 3)
5. Put the assembled piece upside down on the work surface. Insert (4) Plastic Cap (N) into the pre-drilled
holes on the Shelf (G) and Bottom Panel (B). Place the Bottom Panel (B) on the assembled piece. Lift
the Bottom Panel (B) a little bit to allow the Left/Right Door Panels (H&I) into the Plastic Caps (N) on the
Shelf (G) and Bottom Panel (B). Check alignment and secure the Bottom Panel (B) with the remaining
(4) Allen Bolt (K), Spring Washer (L) & Flat Washer (M). (Fig. 5)
N.
N.
I.
H.
B.
J.
K.
L.
M.
(Fig. 5)