Assembly Instruction

4. Insert the Plastic Caps (Q) into the pre-drilled holes on Top/Bottom Panels (A&B). Place the Top Panel (A) on
the assembled piece. Lift the Top Panel a little bit to allow the Door Panels into the Plastic Caps (Q) on
Top/Bottom panels. Check alignment and secure the Top Panel with the remaining (4) Allen Bolts, Flat
Washers & Spring Washers. (Fig. 4)
Top Panel
A
Q
Q
Plastic Cap
Plastic Cap
(Fig. 4)
5. If connecting Cubby piece to Base piece, use (12) Screws (T) and (2) Connecting Brackets (K) as shown. Screws
are self-drilling and are designed to go into wood easily. (Remaining (2) Screws are for the Tip Kit, which has
separate instructions).
6. If connecting Cubby piece to Cubby piece, use (4) screws (T) and (1) Square Connecting Bracket (S) as
shown. Screws are self-drilling and are designed to go into wood easily.