Assembly Instruction

Page 2/2
ASSEMBLY:
1. Place the changing table topper on short dresser in upright position, as shown. Attach the (A) metal
plates to the back edge of the topper by inserting the (B) small Phillips head screw.
(Fig. 1)
2. Adjust the restraint strap to fit baby’s body. To fasten restraint strap, insert the buckle as shown in
Figure 2. To release, press inward on tabs.
(Fig. 2)
3. As a safety precaution, please follow the instructions enclosed to secure the changing table to the wall
using tipping-restraint kit included.
4. If the piece does not sit level, determine which corner does not touch the ground correctly. With two
people follow these steps:
• Carefully elevate the item slightly to provide access to the levelers attached to the bottom.
• Turn the levelers in a counter-clockwise direction or clockwise direction as needed.
• Gently set down the piece and check stability.
• Repeat steps until the furniture sits firmly on the ground
CARE INSTRUCTIONS:
• Dust often using a clean, soft, dry lint-free cloth.
• Blot spills immediately, and wipe with a clean, damp, cloth.
• We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered
finish.
• Check fasteners periodically for tightness. DO NOT over tighten. This may cause distortion or breakage.
• Parents should ensure a safe environment for the child by checking regularly, before placing the child in
the product, that every component is properly and securely in place.
Thank you for your purchase
stores | catalog | www.potterybarnkids.com
USA 1.800.290.8181
To Release
To Fasten