Assembly Instruction

Page 1/2

pottery barn kids

BERKELEY CHANGING TABLE TOPPER

! WARNING: FALL HAZARD - To prevent death or serious

injury from falls, always keep child within arm’s reach.

• Read all instructions before use of the changing table. KEEP INSTRUCTIONS FOR

FUTURE USE.

• Before each use check the changing table for damage, loose parts, or sharp edges. DO

NOT use the changing table if it is damaged or broken.

• Set up this table to be level, stable, and structurally sound.

• This changing table may be used with or without a pad. The only pad approved for use

with it is the Contour Changing Pad available for purchase from pottery barn kids. This

pad is designed to be used in a space of at least 810 mm x 400 mm (32 inches x 16

inches). If used, place it within the rail-bounded changing area of the changing table.

• NEVER LEAVE THE CHILD UNATTENDED and always use the restraining system.

This changing table is intended for use with children weighing up to 50 pounds.

PRE-ASSEMBLY

• Please review all instructions before beginning assembly. The illustrations provided allow for easier

assembly when used in conjunction with the assembly instructions.

• For your safety, assembly by two adults is required.

• Remove all parts and hardware from box and lay out on a carpeted or scratch-fee work surface, as this

will avoid damaging any parts during assembly. The shipping box provides and ideal work surface. Do not

dispose of any contents until assembly is completed to avoid accidentally discarding email parts or

hardware.

• Use the parts and hardware lists to identify and separate each of the piece included.

• Note: do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause

the bolts to misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split

wood.

HARDWARE:

A – Metal plate 94x20x10mm (x2)

B – Phillips head screw 6x15mm (x6)

PARTS INCLUDED:

C — Changing Table Topper

PARTS REQUIRED:

D – Berkeley Dresser

TOOLS REQUIRED:

Phillips head screwdriver (not included)

PAGE 1
pottery barn kids BERKELEY CHANGING TABLE TOPPER ! WARNING: FALL HAZARD - To prevent death or serious injury from falls, always keep child within arm’s reach. • Read all instructions before use of the changing table. KEEP INSTRUCTIONS FOR FUTURE USE. • Before each use check the changing table for damage, loose parts, or sharp edges. DO NOT use the changing table if it is damaged or broken. • Set up this table to be level, stable, and structurally sound.
PAGE 2
ASSEMBLY: 1. Place the changing table topper on short dresser in upright position, as shown. Attach the (A) metal plates to the back edge of the topper by inserting the (B) small Phillips head screw. (Fig. 1) 2. Adjust the restraint strap to fit baby’s body. To fasten restraint strap, insert the buckle as shown in Figure 2. To release, press inward on tabs. (Fig. 2) To Fasten To Release 3.