Assembly Instruction

Page 2/3

ASSEMBLY INSTRUCTIONS:

1. Insert the Side Rail (C) into the hooks located on the end slots of the Front Rail with 1 drawer (A). Push firmly on

the top of the Side Rails (C) until they seat themselves over the pins inside the legs slots as shown. (Fig 1)

2. Repeat Step 1 with the Back rail (B). (Fig. 1)

3. Fix 2 Large Phillips head screws 8x25mm (F) to the wooden cleat of Side rail (C) as shown, tightening with a

Phillips Head Screwdriver. (Fig.2)

4. Attach the Small Mending Plates (G) to the Front panel (E) using the Phillips head screws 6x15mm (H),

tightening with a Phillips Head Screwdriver. (Fig.2)

5. Tighten the levelers as shown. (Fig.2)

Fig. 1