Assembly Instruction

Page 1/3

pottery barn kids

BELDEN 1-DRAWER BED

PRE-ASSEMBLY:

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used

in conjunction with the assembly instructions.

• For your safety and ease, assembly by two adults is recommended.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use

care as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or

hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split wood.

PARTS INCLUDED:

(A) – Front Rail with 1 drawer (1pc)

(B) – Back Rail (1 pc)

(D) – Slat Roll (1 pc)

(E) – Front Panel (1 pc)

TOOLS REQUIRED:

Phillips Head Screwdriver (not included)

HARDWARE INCLUDED:

(F) – Large Phillips Head Screw 8x25mm(34 pcs)

(G) – Small Mending Plate 70x40x3mm (2 pcs)

(H) – Phillips Head Screw 6x15mm (8 pcs)

PAGE 1
pottery barn kids BELDEN 1-DRAWER BED PRE-ASSEMBLY: • Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions. • For your safety and ease, assembly by two adults is recommended. • Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use care as some parts or hardware may have sharp points or edges.
PAGE 2
ASSEMBLY INSTRUCTIONS: 1. Insert the Side Rail (C) into the hooks located on the end slots of the Front Rail with 1 drawer (A). Push firmly on the top of the Side Rails (C) until they seat themselves over the pins inside the legs slots as shown. (Fig 1) 2. Repeat Step 1 with the Back rail (B). (Fig. 1) Fig. 1 3. Fix 2 Large Phillips head screws 8x25mm (F) to the wooden cleat of Side rail (C) as shown, tightening with a Phillips Head Screwdriver. (Fig.2) 4.
PAGE 3
6. Lay the Slat roll (D) in-between the Front rail (A) and the Back rail (B), and secure to the bed frame using 32 pcs Large Phillips head screws 8x25mm (F). Loosely tighten with the Phillips Head Screwdriver. (Fig.3) F * The Front Panel (E) can be changed from left to right as shown. Fig. 3 7. Tighten all bolts and screws to make sure all are tight and bed structure is rigid. We recommend all screws be checked periodically for safety, as the hardware may loosen over time.