Assembly Instruction

pottery barn kids
surf shack
for age 3 and up à partir de 3 ans
PRE-ASSEMBLY:
Read all instructions before beginning assembly.
For your safety and ease, assembly by two adults is
recommended.
Remove all part and hardware from the box and lay
out on a clean carpet, or scratch - free work
surface. Be careful as some parts or hardware may
have sharp points or edges.
Do not dispose of any contents until assembly is
completed to avoid accidentally discarding small parts
and hardware.
Use the parts and hardware lists to identify and
separate each of the pieces included.
Note: Do not fully tighten all bolts until all parts are in
place. Failure to follow these instructions may cause
the bolts misalign during assembly.
The use of power tools for assembly is not
recommended. Power tools can damage hardware or
split wood.
HARDWARE INCLUDED / MATÉRIEL COMPRISES:
1. (2) M8 Bolt/ VERROU 2. (8) M6 Long Bolt / LONG VERROU 3. M6 Short Bolt / COUR VERROU
4. (8) Barrel Bolt / VERROU
5. (4) Screw / VIS 6. (12) Wood dowel / GOUJON EN BOIS
7. (2) Large Flat Washer / GRANDE RONDELLE PLATE
8. (2) Large Lock asher / GRANDE RONDELLE
9. (14)
Small Flat Washer / PETITE RONDELLE PLATE 10. (14) Small Lock Washer / PETITR RONDELLE
Page 1 of 5
hutte de surf
CAUTION: Adult assembly required. This item contains small
parts in the unassembled state and care should be taken in the
unpacking and assembly of the product.
MISE EN GARDE : Assemblage par un adulte nécessaire. Non
assemblé, cet article comprend de petites pièces et il faut donc
le déballer et l’assembler avec soin.
AVANT DE COMMENCER L’ASSEMBLAGE :
Veuillez lire toutes les instructions avant de commencer
l’assemblage.
Pour votre sécurité et votre confort, l’assemblage
devrait être fait par deux adultes.
Retirez toutes les pièces et le matériel contenus dans la
boîte et disposez-les dans une aire dégagée sur du
tapis ou une surface qui ne causera pas d'éraflures.
Faites attention puisque des pièces ou du matériel
peuvent avoir des pointes ou des arêtes affûtées.
Ne jetez rien du contenu avant que l’assemblage ne
soit terminé afin d’éviter de jeter par mégarde de petites
pièces ou du matériel.
Servez-vous de la liste des pièces et du matériel ci
dessus
pour identifier et séparer toutes les pièces
incluses.
Remarque : Ne serrez pas les boulons complètement
avant d’avoir installé toutes les pièces. Si vous ne
suivez pas ces instructions, les boulons pourraient mal
s’aligner durant l’assemblage.
Il n’est pas recommandé d’utiliser des outils électriques
pour l’assemblage. Les outils électriques peuvent
endommager la quincaillerie ou fendre le bois.

Summary of content (5 pages)