Assembly Instruction

Instructions How to set up basic playard
Step 1
• Unzip bag. Remove playard and stand playard upright.
• Unhook Velcro
®
tabs.
• Set mattress aside.
Step 2
• Separate the four corner posts. Leaving center up.
• Lock all top bars by grasping top bar in center and pulling up until
you hear a "click"
• Repeat on all 4 sides until all top bars are rigid.
Step 3
• Place foot on outside center pocket of bottom bar and push down to lock.
• Repeat on all 4 sides until playard is fully erect.
Step 4
A. To cover mattress with fitted sheet open the 4 Velcro
®
tabs with snap
found on corner ends of mattress.
B. Feed Velcro
®
tabs thru buttonholes in sheet corners & place in bottom
of playard with Velcro
®
tabs extended.
C. Feed Velcro
®
tabs thru corresponding buttonholes in floor of playard
corners and attach to snap on outside of leg.
DO NOT PUSH CENTER DOWN OR LOCK LOWER BARS
BEFORE LOCKING ALL TOP BARS.
WARNING: STRANGULATION HAZARD: When anchor plate and strap assembly is not in use,
store in a safe place not accessible to children.
WARNING: When converting to the playard configuration, remove the plastic hangers, the liner
and floor support rods. Lower the floor to the LOWEST level. Place the removable bar in the HIGHEST position.
• Always make sure all top and bottom rails are securely locked, in all configurations, before putting an
infant/child into the unit.
• NEVER LEAVE infant in playard with SIDES DOWN. Infant may roll into space between pad and loose mesh
side causing suffocation.
!
!
6