Assembly Instruction

Page 3/4

3. Align the predrilled holes on the Short Side Rails (F) to the wooden dowels on ends of the (2) Long Side

Rails (D & E). Slide a Spring Washer (K) and a Flat Washer (L) into an Allen Bolt (J), and then insert the

Bolt into predrilled hole on the Short Side Rail (F). Place Barrel Nut (H) in the corresponding opening on

the Long Side Rail and use Allen Key (I) to connect, as shown in Figure 3. Repeat with the remaining (7)

bolts.

Note: To access the bottom Barrel Nut openings, assemble the four upper bolts and then turn

the assembled structure upside down to assemble the four bottom bolts. Do not fully tighten

until all bolts are in place.

Figure 3