Assembly Instruction

ManualsBrandsPottery Barn ManualsBedroomPottery Barn Anderson Trundle

Page 1/4

pottery barn kids

ANDERSON TRUNDLE

PRE-ASSEMBLY:

• For your safety and ease, assembly by two adults is recommended.

• Please read all instructions before beginning assembly. The illustrations provided allow for easier assembly

when used in conjunction with the assembly instructions.

• Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface. The shipping

box provides and ideal work surface. Do not dispose of any contents until assembly is completed to avoid

accidentally discarding small parts or hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included prior to starting

assembly.

• Note: DO not fully tighten the bolts until all parts are in place. Failure to follow these instructions may cause

the bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.

HARDWARE INCLUDED:

(G) Long Wood Screw 4 x 30mm

– 22pcs

(H) Barrel Nut – 8pcs

(I) Allen Key – 1pc

(J) Allen Bolt ¼” x 60mm – 8pcs

(K) Spring Washer – 4pcs

(L) Flat Washer – 4pcs

(M) Caster – 6pcs

(N) Short Wood Screw 4 x 13mm

– 24pcs

PARTS INCLUDED:

(A) Left and Right Board (with extra holes)– 2pcs

(B) Center Bottom Board – 1pc

(D) Long Side Rail – 1pc

(E) Long Side Rail with Decor – 1pc

(F) Short Side Rail – 2pcs

TOOLS REQUIRED:

Philips Screwdriver (Not included)

Summary of content (4 pages)

PAGE 1
pottery barn kids ANDERSON TRUNDLE PRE-ASSEMBLY: • For your safety and ease, assembly by two adults is recommended. • Please read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions. • Remove all parts and hardware from box and lay out on a carpeted or scratch-free work surface. The shipping box provides and ideal work surface.
PAGE 2
ASSEMBLY INSTRUCTIONS: 1. Lay the Left and Right Bottom Boards (A) on either side of the Center Bottom Board (B) with the pre-drilled holes facing up, as shown in Figure 1. Attach (2) Cross Bars (C) to the bottom boards by inserting (12) Long Wood Screws (G) into the pre-drilled holes of each cross bar, tightening with the Philips Screwdriver. Figure 1 G A. B. A. 2. Turn assembled base upside down.
PAGE 3
. Align the predrilled holes on the Short Side Rails (F) to the wooden dowels on ends of the (2) Long Side Rails (D & E). Slide a Spring Washer (K) and a Flat Washer (L) into an Allen Bolt (J), and then insert the Bolt into predrilled hole on the Short Side Rail (F). Place Barrel Nut (H) in the corresponding opening on the Long Side Rail and use Allen Key (I) to connect, as shown in Figure 3. Repeat with the remaining (7) bolts.
PAGE 4
. Turn trundle on its side. Secure Bottom Boards with the Long/Short Side Rails using the remaining (10) Long Wood Screws (G). Figure 4 5. Attach the (6) Casters (M) to predrilled holes on the Bottom Boards using (24) Short Wood Screws (N). Figure 5 M N M N CARE INSTRUCTIONS: • Dust often using a clean, soft, dry lint-free cloth. • Blot spills immediately, and wipe with a clean, damp, cloth.