Instruction Manual

20
PFC-9000 • 5403535 • REV G • 9/08
The RA-LCD has a continuity jumper (JW1) that is removed on all annunciators except the last one.
The RA-LED32 must be addressed as the number of annunciator as it is in the system. The table below is the switch setting
necessary for addressing the annunciator.
The “ON” setting is active for the RA-LCD annunciator.
The SW2 is the switch that enables/disables the common push buttons of the RA-LED32. The following switches will disable the
common features.
hctiwSPID
snoitisoP
"sserddA"rotaicnunnAyalpsiD
334353637383930414243444546474
1-1WS
FFONOFFONOFFONOFFONOFFONOFFONOFFONOFFO
2-1WS
NOFFOFFONONOFFOFFONONOFFOFFONONOFFOFFO
3-1WS
NONONOFFOFFOFFOFFONONONONOFFOFFOFFOFFO
4-1WS
NONONONONONONOFFOFFOFFOFFOFFOFFOFFOFFO
5-1WS
NONONONONONONONONONONONONONONO
6-1WS
FFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFO
hctiwSPID
snoitisoP
"sserddA"rotaicnunnAyalpsiD
84940515253545556575859506162636
1-1WS
NOFFONOFFONOFFONOFFONOFFONOFFONOFFONOFFO
2-1WS
NONOFFOFFONONOFFOFFONONOFFOFFONONOFFOFFO
3-1WS
NONONONOFFOFFOFFOFFONONONONOFFOFFOFFOFFO
4-1WS
NONONONONONONONOFFOFFOFFOFFOFFOFFOFFOFFO
5-1WS
FFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFO
6-1WS
FFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFOFFO
hctiwSPID
snoitisoP
"sserddA"rotaicnunnADEL-AR
12 34 56789 011121314151
)0A(1-1WS
NOFFONOFFONOFFONOFFONOFFONOFFONOFFONO
)1A(2-1WS
FFONONOFFOFFONONOFFOFFONONOFFOFFONONO
)2A(3-1WS
FFOFFOFFONONONONOFFOFFOFFOFFONONONONO
)3A(4-1WS
FFOFFOFFOFFOFFOFFOFFONONONONONONONONO
SW1-1 = Address A0
SW1-2 = Address A1
SW1-3 = AddressA2
SW1-4 = AddressA3
SW1-5 = Not Used
SW1-6 = Not Used
SW1-7 = Not Used
SW1-8 = Not Used
SW2-1 = Disable System Reset Button
SW2-2 = Disable Fire Drill Button
SW2-3 = Disable Acknowledge Button
SW2-4 = Disable General Alarm Button
SW2-5 = Not Used
SW2-6 = Disable Auxiliary Disconnect Button
SW2-7 = Not Used
SW2-8 = Disable Signal Silence Button
RA-LCD Dip Switch Position
The “OFF” setting is the active setting for the RA-LCD annunciator and all of the dipswitches are binary. The following table
indicates the dip switch position for each address for the RA-LCD, switches 7 and 8 are not used: