Specification

3
B. Ensure property lines and legal boundaries of work are clearly established.
3.02 INSTALLATION
A. Install fence in accordance with manufacturer’s instructions.
B. Space posts uniformly at 8’ OC maximum unless otherwise indicated (due to wind load or fence style
requirements).
B.01 Vertical Style Spacing Chart (Windload requirement)
Vertical Fence Height: 8ft Max On-Center Post Spacing 4ft
Vertical Fence Height: 7ft Max On-Center Post Spacing 5ft
Vertical Fence Height: 6ft Max On-Center Post Spacing 8ft
Vertical Fence Height: 5ft Max On-Center Post Spacing 10ft
Vertical Fence Height: 4ft Max On-Center Post Spacing 10ft
B.02 Horizontal Style Spacing Chart (Fence Style requirement)
Horizontal Fence All Heights Max On-Center Post Spacing 4ft
C. Concrete Set Posts: Drill hole in firm, undisturbed or compacted soil. Holes shall have diameter 4 times greater
than nominal outside dimension of post, and depths approximately 6” (152 mm) deeper than post bottom.
Excavate deeper as required for adequate support in soft and loose soils and for posts with heavy lateral loads.
Set post bottom 36” (914 mm) below surface when in firm, undisturbed soil. Place concrete around post in a
continuous pour. Trowel finish around posts and slope to direct water away from posts.
1. Gate Posts and Hardware: Set keepers, stops, sleeves and other accessories into concrete.
D. Surface mount (wall mount) posts with mounting plates where indicated. Fasten with lag bolts and shields.
E. Check each post for vertical and top alignment, and maintain in position during placement and finishing operation.
3.03 GATE INSTALLATION
A. Install gates plumb, level and secure for full opening without interference.
B. Attach hardware by means which will prevent unauthorized removal.
C. Adjust hardware for smooth operation.
3.04 CLEANING
A. Clean up debris and unused material and remove from site.