Instruction manual

1. DISCLAIMER

including respective references have been verified and found to be legitimate. In

particular in the event of error they may, therefore, be changed at any time without prior

notice. The complete risk inherent in the utilization of this document or in the results of

its utilization shall be with the user; to this end, ELTEC Elektronik AG shall not accept

any liability. Regardless of the applicability of respective copyrights, no portion of this

document shall be copied, forwarded or stored in a data reception system or entered

into such systems without the express prior written consent of ELTEC Elektronik AG,

regardless of how such acts are performed and what system is used (electronic,

mechanic, photocopying, recording, etc.). All product and company names are

registered trademarks of the respective companies.

Our General Business, Delivery, Offer, and Payment Terms and Conditions shall

otherwise apply.

Federal communications commission statement

• This device complies with FCC Rules Part 15. Operation is subject to the following

two conditions:

• This device may not cause harmful interference, and

• This device must accept any interference received including interference that may

cause undesired operation.

• This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with manufacturer's instructions, may

cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from that to which the

receiver is connected.