Instruction manual

3.2.4. Hex-Switch (Board-ID-Select)
Switch S700 is used to set the board ID. If more than one frame grabber is plugged into the PC, each
must have a distinct board ID unequal to "0".
3.2.5. Status-LEDs
There are 4 LEDs for status information:
Frame Grabber LEDs
Table 3.5. frame grabber LED
LED1: Board selected - when the frame grabber is initialized, the LED is switched
on
LED2: Capture - Acquisition in progress
LED3: FiFo overrun - The FiFo has run full
LED4: FiFo Write Enable - video data is written into the FiFo
These LEDs are not intended to be used in applications but to help in analyzing problems in cooperation
with ELTEC Elektronik AG support.
Chapter 3. Hardware Reference
23