User's Manual

Enabling the BB-3000W Bump Bar

Before enabling the BB-3000W bump bar, install two AA Alkaline batteries in

the bump bar and attach the USB dongle to your host terminal by referring to

the following instructive steps.

1. Loosen and remove the screw from the battery

cover of the BB-3000W bump bar.

2. Load two AA Alkaline batteries into the battery

compartment of the bump bar. When the

batteries are loaded, the LED status indicator

stays bright in solid green for about 5 seconds;

when the battery is low, the LED status indicator

flashes in red.

3. Close the battery compartment of the bump bar

with the battery cover, and securely fix the cover

with the screw.

4. Attach the USB dongle to your host terminal.

Then, the BB-3000W bump bar is automatically

paired with the USB dongle attached to the

working terminal as long as the channel number

on the USB dongle is the same as that on the

BB-3000W bump bar; if the channel number on

the USB dongle is different from that on the

BB-3000W bump bar, the pairing will fails.

When replacing the batteries, always use

“Alkaline” AA type batteries.

USB dongle attached