User manual

Poseidon MKVI User Manual Appendix 1
Page 72
T# Time (sec) Description Error Code Solution
1
3
5
2
4
6
System Data Log Integrity Test. This test ensures that the data
log circuitry in the Primary Display is functional and accessible.
Display EEPROM. This tests the EEPROM (static memory) in the
Primary Display, which contains user-selectable conguration
information, for internal errors or data corruption.
HUD EEPROM. This tests the EEPROM (static memory) in the
HUD (Head-Up Display), which contains user-selectable con-
guration information, for internal errors or data corruption.
Display ROM / RAM / Fuses. This tests the RAM, ROM and
fuse settings of the electronics in the Primary Display. The
RAM is tested only when the battery is inserted, and the
results used for all subsequent power-up routines. Other tests
are conducted on each power-up routine.
HUD ROM / RAM / Fuses. This tests the RAM, ROM and fuse
settings of the electronics in the HUD (Head-Up Display). The
RAM is tested only when the battery is inserted, and the
results used for all subsequent power-up routines. Other tests
are conducted on each power-up routine.
Backpack ROM / RAM / Fuses. This tests the RAM, ROM and
fuse settings of the electronics in the backpack processor.
The RAM is tested only when the battery is inserted, and the
results used for all subsequent power-up routines. Other tests
are conducted on each power-up routine.
1,5
1
1
1
1
5
2=Bad Chip
6=Bad
EEPROM
6=Bad
EEPROM
4=Bad RAM
5=Bad Fuse
4=Bad RAM
5=Bad Fuse
4=Bad RAM
5=Bad Fuse
3=Bad ROM
3=Bad ROM
3=Bad ROM
1) Standard Response; 2) If test failure persists, contact an authorized
Poseidon Service Center for repair.
1) Standard Response; 2) If test continues to fail, reset system parameters;
3) If test failure persists, contact an authorized Poseidon Service Center for
repair.
1) Standard Response; 2) If test continues to fail, reset system parameters;
3) If test failure persists, contact an authorized Poseidon Service Center for
repair.
1) Standard Response; 2) If test failure persists, contact an authorized
Poseidon Service Center for repair.
1) Standard Response; 2) If test failure persists, contact an authorized
Poseidon Service Center for repair.
1) Standard Response; 2) If test failure persists, contact an authorized
Poseidon Service Center for repair.
1) Standard Response; 2) If test continues to fail, attempt to reinstall
Firmware (may cause unrecoverable failure); 3) If test failure persists, contact
an authorized Poseidon Service Center for repair.
1) Standard Response; 2) If test continues to fail, attempt to reinstallFirm-
ware (may cause unrecoverable failure); 3) If test failure persists, contact an
authorized Poseidon Service Center for repair.
1) Standard Response; 2) If test continues to fail, attempt to reinstall
Firmware (may cause unrecoverable failure); 3) If test failure persists, contact
an authorized Poseidon Service Center for repair.
Always ensure that battery is adequately charged (but not over-charged) before attempting automatic pre-dive routine. The standard response to any test failure should be an attempted reboot.
Repeated failures of the same test (including Error Code 0) may sometimes be solved by removing the battery, placing it on the charger for a few minutes, then re-inserting on the electronics.
NEVER remove the battery until after the system has powered-down! Time values are maximum seconds allowed for each test.