User manual

Poseidon MKVI User Manual
Chapter 1
Page 27
11. Front CC hoses to counter lung T-section
Connect the left front CC loop hose to the inhalation counter lung T-connection.
Connect the right front CC loop hose to the exhalation counter lung T-connection.
Lay out the two remaining breathing hoses. Connect the right front breathing hose to the front port
of the right counterlung water diversion manifold (Figures 1-43). All of the previously mentioned
practices concerning inspection and lubrication of o-rings and o-ring receiving surfaces apply.
Hand tighten the hose retainer nut as shown in Figure 1-43. Use NO tools. Repeat this process
for the left front breathing hose attachment to the front port of the water diversion manifold for
the left counterlung. The result should now appear as shown in Figure 1-42.
”Radial” o-ring seal
Sealing surface for ”radial” o-ring seal
Retainer nut capture thread
Figure 1-43. Hand tighten (clockwise) the swivel nuts for the front breathing
hoses at the front shoulder ports. DO NOT use tools or over-tighten.
Figure 1-42. Breathing hoses properly connected onto the water diversion manifolds.