User's Manual

2
A
NTI CAR
-
HIJACKING
(
FUNCTION SELECTION
7)
a. When ACC ON and doors are closed, press button 3 once, and open the door within 8
sec to activate anti car-hijacking mode.
b. System will enter anti car-hijacking mode after closing the door, and 30-second
countdown starts.
c. After 30 seconds, siren will sound once for every 2 seconds, 20 seconds later, siren will
sound continuously and parking lights will flash continuously.
d. Siren will stop sounding & parking lights will stop flashing when ACC OFF. After ACC
OFF, engine is not able to start again (if kill starter relay connected).
e. Disarm the anti car hijacking: Press button 3 for over 2 seconds when ACC ON or OFF.
The parking lights will flash 4 times for notification, the siren shall chirp four times to
indicate. Or apply the emergency override procedure.
E
NGINE START SELF
-
CHECKING
a. In disarmed mode, turn ignition from OFF to ON, then OFF within 3 seconds.
b. Then, press valet switch 3 times within 10 seconds, the siren will chirp once, indicating
the system enters the self-checking mode.
c. When in self-checking mode, press button 4 for 2 seconds to start the self-checking
process. If everything is OK, engine will be started. If problems occur, car can not be
started and system will indicate the problem by chirp and flash:
1. If the engine is already running: siren chirps once and parking light flashes once.
2. If foot brake isn’t released: siren chirps 3 times, parking lights flash 3 times.
3. If hood ON: siren chirps 4 times, parking lights flash 4 times.
4. If hand brake isn’t pulled up: siren chirps 6 times, parking lights flash 6 times.
RPM
LEARNING MODE
a. When disarmed, turn ignition ON.
b. Press valet switch 6 times within 10 sec, the siren will chirp once to indicate that system
has entered the RPM learning mode.
c. Start the engine, when the RPM level is stabilized, press the valet switch for 2 sec, the
LED will be ON for 2 sec, the siren will chirp twice, which indicates the RPM learning
has been operated successfully.
R
EMOTE START BOOKING
(
SEE FUNCTION SELECTION
22)
A. STICK SHIFT CAR: When parking the car, pull up the hand brake, release the foot
brake, and place the gearshift in the neutral position. And within the 2 min, turn ignition
OFF, the door will unlock automatically, and the engine will be still running for 2 min.
After the door is closed, the engine will stop running immediately. The siren will chirp
once, which indicates the remote start booking is successful and the system will allow
REMOTE START. If any door is opened or engine is started, remote start booking is
cancelled.
B. AUTO-SHIFT CAR: When parking the car, (pull up the hand brake), release the foot
brake, after putting the gear in PARKING position, turn ACC OFF, the door will be
unlocked.
T
IMER START BOOKING AND TIMER START
(
SEE FUNCTION SELECTION
27-31)
a. When parking the car, press button 2+4 once at the
same time, parking lights will flash 3 times, and then
please perform the REMOTE START BOOKING
procedures. Siren will chirp 2 times (Auto shift car
no chirp), there will have a sigh of 24H on LCD of
T20, which shows that engine will be started after 24
hours. At the same time, engine can be started
remotely.
b. During the 24 hours, if the door is opened, engine is started or engine is started remotely,
then TIMER START BOOKING is cancelled.
c. The time of TIMER START BOOKING can be
24H, 12H, 8H, 4H and 2H.
TURBO
Press button 1+4 at the same time for 2 seconds, there
will have a sign of TURBO on T20H transmitter.
When start booking with TURBO mode selected, engine will continue running for 2 min
when ACC is turned from ON to OFF, and engine will stop running immediately if step foot
brake or release hand brake.
R
EMOTE START
a. First of all, car alarm must be set REMOTE START BOOKING or TIMER START
BOOKING to enable remote starter function.
b. Press button 4 for 2 seconds, the function is activated. The siren will chirp once for
indication.
c. Then system will automatically start self-checking procedure; if everything is OK, the
engine will be started within 5 sec. If car can not be started and system will indicate the
problem by chirp and flash:
1. If the engine is already running: siren chirps once and parking light flashes once.
2. If foot brake isn’t released: siren chirps 3 times, parking lights flash 3 times.
3. If hood ON: siren chirps 4 times, parking lights flash 4 times.
4. If hand brake isn’t pulled up: siren chirps 6 times, parking lights flash 6 times.
d. When the engine is started successfully, the starter will be off at once, after 2 sec, the
parking lights will be ON constantly and air-conditioner will be turned on at the same
time if air-conditioner is ON already.
e.
If the engine is not started at the first time, the system will allow 3 time’s trials. If the
engine is off, the siren will chirp once and parking lights will flash once for failure indication.
f. The remote starter will run for 10 minutes (or 20 minutes). Meanwhile, if the door is
opened without using transmitters or in arming mode, the engine will stop and the siren
will sound immediately. When in disarmed mode, the engine won’t stop and the siren
won’t sound.
g. If the driver wish to drive the car while in warm-up process, press button 2 to unlock
door, turn ACC ON, then the car can be driven.
R
EMOTE TRUNK RELEASE
Press button 2+3 to release trunk at any time.
EEPROM
MEMORY FUNCTION
System will memorize the preset code and the conditions when the power is cut off.
2-
STAGE SHOCK SENSOR
a. If car is lightly knocked once, siren will chirp once and parking lights will flash once for
warning. And T20H will sound bi-po, bi-po for reminder.
b. If the car is knocked again within 8 seconds, siren will sound and parking lights will
flash for 30 seconds. And T20H will sound wo-wo-wo continually for reminder.
c. If car receives a heavy knock, system will be triggered immediately. Siren will sound
and parking lights will flash for 30 sec. And T20H will sound wo-wo-wo continually for
reminder.
A
DDITIONAL TRIGGER SENSORS
Other trigger sensor can be added to the system to enhance security. Ultrasonic sensor (UL-
100), microwave sensor (MW-100) or glass breakage sensor (GS-100). Please refer to your
installer for more details.
F
UNCTION SELECTION
The function selection is programmable. Please follow the procedures:
a. Disarm the system.
b. Turn ignition ON.
c. Press Valet switch 7 times within 8 sec. After 8 seconds, the siren will chirp once.
d. Turn ignition OFF, then the LED will flash slowly.
e. Press the valet switch with the function numbers you would like to change (Siren will
chirp once when pressing the valet switch once). Turn ACC ON, siren will chirp one or
two times: one chirp means preset value, two chirps mean variable value. All the
progress much be finished within 30 sec.
f. For other function selection, please turn ACC OFF, the LED will flash slowly and please
return to step e.
FUNCTION SELECTIONS PRESET VALUE
1 CHIRP
VARIABLE SET-UP
2 CHIRPS
1. LOCK/UNLOCK TIME 0.5 SEC 3.5 SEC.
4. IGNITION ON WITH/WITHOUT
DOOR LOCK
DOOR LOCK DOOR UNLOCK
7. ANTI-CAR HIJACKING ON OFF
8. AUTO ARMING ON OFF
9. AUTO ARMING WITH/WITHOUT
DOOR LOCK
DOOR LOCK DOOR UNLOCK
10. RE-ARMING ON OFF
11. RE-ARMING WITH/WITHOUT
DOOR LOCK
DOOR LOCK DOOR UNLOCK
12. VALET MODE ON OFF
21. DOOR OPENED WARNING ON OFF
22.STICK SHIFT/AUTO-SHIFT CAR AUTO SHIFT STICK SHIFT
23. SIREN /LAMP SELECTION TRIGGERED, ONLY
FLASH AND NO SOUND
DURING THE FIRST 4
SEC
SOUND AND FLASH
AT THE SAME TIME
24. GASOLINE/DIESEL GASOLINE DIESEL
25. WARM UP TIME 10 MIN 20 MIN
27. TIMER START 24 H (DEFAULT) *
28. TIMER START OFF (2 CHIRPS) 12H (ONE CHIRP)
29. TIMER START OFF (2 CHIRPS) 8 H (ONE CHIRP)
30. TIMER START OFF (2 CHIRPS) 4 H (ONE CHIRP)
31. TIMER START OFF (2 CHIRPS) 2H (ONE CHIRP)
32. DEFAULT PRE SET VALUE *
Remark: if timer-starting time is 2 hours, then 4H, 8H, 12H and 24H are also available, the
priority turn is 2—4---8----12---24 (hour).
LED
STATUS
a. In armed mode, the LED flashes slowly 1 time/sec.
b. In arming mode, if the sensor is by-passed, LED will flash quickly 2 times/sec.
c. If the alarm is triggered, the LED will flash quickly 2 times/sec.
C
AR CALL
When armed, to knock slightly at the Car Call on the windshield to call the driver, T20H
transmitter will sound for reminder. After receiving signals, press any button on the
transmitter, the siren will chirp 6 times for confirmation.
Notice :
The changes or modifications not expressly approved
by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
REV: C