User's Manual

9
H6. 4-PIN CONNECTOR FOR ANTENNA
ANT
The 2-way transceiver/antenna mounting location should be the upper left or lower left corner of the driver’s
windshield.
H7. 3-PIN CONNECTOR FOR TEMPERATURE SENSOR
TEMPERATURE SENSOR (Optional)
The Temperature sensor can be add on. You can monitor, through the temperature sensor’s LED screen, the
present indoor temperature of the passenger compartment before cooling or heating your vehicle.
It can also can be programmed to automatically start the vehicle engine whenever the temperature inside the
vehicle reaches or drops below the programmed temperature level.
H8. 2 PIN CONNECTOR FOR THE LED STATUS INDICATOR:
LED
The led indicator status should be mounted in a highly visible area such as top of the dashboard, on top of the
shifter console or on dashboard face. Leave at least 6mm space behind the mounting location for LED housing.
Once a suitable location is chosen, drill a 6mm hole. Run the LED wires through the hole then press the 2 pin
LED housing into the place. Route the LED wires to the control module.
H9. 2 PIN CONNECTOR FOR THE VALET SWITCH
VALET
Select a mounting location for the switch that is easily accessible to the driver of the vehicle. The switch does
not have to be concealed, however, concealing the switch is always recommended, as this provides an even
higher level of security to the vehicle. Mount the valet switch in a hidden but accessible location. Route the
valet switch wires to the control module.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Caution:
The changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.