User's Manual
8
H3-8 Grey/black wire – (-) Diesel Wait – To - Start Input –
In diesel vehicles it is necessary to interface with the wire that on the WAIT-TO-START light in the dashboard.
This wire illuminates the bulb until the vehicle’s glow plugs are properly heated. When the light goes out the
vehicle can be started. This wire is always at the connector leading to the bulb in the dashboard. It can also be
found at the Engine Control Module (ECM) in many vehicles.
To test and determine the polarity of this wire:
1. Set your multi-meter to DVC or DC voltage (12V or 20V is fine).
2. Attach the (+) probe of the meter to (+) 12V.
3. Probe the wire that you suspect leads to the bulb with the (-) probe of the meter.
4. Turn the ignition switch to the ON position.
5. If the meter indicates 12 volts until the light goes out you have isolated the connect wire and the wire’s
polarity is negative (ground while the bulb is on).
6. If the meter reads zero volts until the light goes out and then reads 12 volts, you have isolated the connect
wire and the wire’s polarity is positive. Connect this wire to the wire in the vehicle that sends the signal to turn
on the WAIT-TO-START bulb in the dashboard. In most diesels the wire is negative (ground turns on the bulb)
and this wire can be directly connected to the wire in the vehicle. If the vehicles use a positive wire (12V to turn
the bulb) a relay must be used to change the polarity.
H4 3-pin connector for Door lock & Door unlock Connection.
1.GREEN: (-)LOCK, (+)UNLOCK OUTPUT
3. BLUE: (+)LOCK, (-)UNLOCK OUTPUT
H4-1 Green (-) Lock, (+) Unlock Output
H4-3 Blue (+) Lock, (-) Unlock Output
The control module can control 2 common power door lock types without any additional parts. With certain
vehicles, or if an actuator is to be installed, either a 451M Door Lock Re lay Satellite or relays will be required.
H5. 4 PIN CONNECTOR FOR 2 STAGE SHOCK SENSOR
1.Turn clockwise to adjust sensitivity to Hi
2.Make sure the sensor is closely attached to vehicle
3.LED ON indicates triggering
SHOCK SENSOR