User's Manual

H3-2 Grey wire – Ground Instant Trigger Input –

This wire is the ground trigger input wire for hood/trunk pin switches.

H3-3 Black/white Negative safety shut down input -

The green wire provides an instant shutdown for the remote start, whenever it is grounded. Connect the wire to

the hand switch previously installed.

H3-4 Yellow Positive safety shut down input -

This wire provides an instant shutdown for the remote start, whenever it get +12 volts . If the brake lights

switch in the vehicle switches + 12 volts to brake light circuit, connect this wire to output side of the brake

switch. This will allow the remote start to shut down if an attempt is made to operate the vehicle without the

key while running under the control remote start.

H3-5 Purple wire – Positive Door Switch Sensing Input –

This wire is the positive trigger input wire for positive door pin switch. This wire is connection for "positive"

type factory door pins(typical FORD MOTOR). Locate the "common wire" for all door pins and make the

connection of the white Wire here.

H3-6 Green wire – Negative Door Switch Sensing Input –

This wire is the ground trigger input wire for negative door pin switch. This wire is connection for "grounding"

type factory door pins locate the "common wire" that connects the door pin switches. Make the connection of

the brown Wire here.

H3-7 White/blue wire – (-) Instant Start & Turn Off Input –

This wires activates and turns off the remote starter each time it sees a momentary ground signal.

BLACK/WHITE HAND BRAKE

YELLOW FOOT BRAKE

+12V

DOOR TG-

GREEN

DOORTG+

+12V

PURPLE