User's Manual

PURPLE/WHITE

RPM

H2-11 Blue/black wire – (-) 300mA Channel 3 Output –

Same function as H2-2. This feature allows you to remote other electric device.

H2-12 Orange/black wire – (-) 300mA Channel 2 Output –

This will become a 1 second pulse ground by activate channel 3 on transmitter for two seconds, the current

capacity of this wire is 300 mA. This feature allows you to remote other electric device.

H2-13 Orange wire – (-) 300mA Grounded Output When Armed –

This wire will become grounded when the alarm is armed. The current capacity of this wire is 300mA. This

output can control starter disable, when an intrusion is detected and the system is triggered. The vehicles

prevent from any unauthorized starting.

H2-14 Black wire – System Ground –

This is main ground connection of the alarm module. Make this connection to a solid section of the vehicle

frame. Do not connect this wire to any existing ground wires supplied by the factory wire loom, make the

connection to the vehicle's frame directly.

H3 8-PIN INPUT CONNECTOR

GREY/BLACK WAIT TO START

YELLOW FOOT BRAKE

WHITE/BLUE START SW

PURPLE/WHITE RPM

BLACK/WHITE HAND BRAKE

PURPLE +TG

GREEN -TG

GREY -TG

H3-1 Purple/white – Tachometer Signal connection

This input provides the remote start system with information about the engine’s revolutions per minute (RPM).

It can be connected to the negative side of the coil in a vehicle with conventional coils. In Multi-coil and high

energy ignition system locating a proper signal may be more difficult.

STARTER

RELAY

KEYON

LOCK

ORANGE