User's Manual

Warning: This wire must be connected to the vehicle side of the starter cut relay (when used). For the electrical

neutral switch configuration, this connection must be make between the starter inhibit relay (when used ) and

the neutral safety switch as shown in the following diagram.

Failure to connect this wire to the ignition switch side of the neutral safety switch can result in personal injury

and property damage.

H1/4 Yellow wire – Ignition 1 Output –

Connect the yellow wire to the ignition wire from the ignition switch. The ignition wire should receive “12V

volts” when the ignition key is the “ON” or “RUN” and “START” or “CRANK” position. When the ignition is

turned “OFF”, the ignition wire should receive “0” voltage. The yellow wire must be connected.

H1/5 Brown wire – ignition 2 output.

Some vehicles have (2) ignition wires that must have power. Connect the brown wire to ignition 2 wire from

the ignition switch. The ignition wire should receive “12” volts when the ignition key is in the “On” or “RUN”

and “START” position. When the ignition is turned “OFF”, the ignition wires should receive “0” voltage. If the

brown is not used, cap the end of the wire.

H1/6 Orange wire – Accessory Output (Heater/ ACC Output) –

Connect the orange wire to the accessory wire in the vehicle that powers the climate control system.

An accessory wire will show + 12 volts when the ignition switch is turned to the “ACC” or “ON” and “RUN”

positions, and will show 0 volts when the key is turned to the “OFF” or “ START” OR “CRANK” positions.

There will often more than one accessory wire in the ignition harness. The correct accessory wire will power

the vehicle’s climate control system. Some vehicle may have separated wires for the blower motor and air

conditioning compressor. In such cases, it will be necessary to add a relay to power the second accessory wire.

H2 14-PIN OUTPUT WIRE CONNECTION

BLACK SYSTEM GROUND

ORANGE/BLACK L2 -300mA OUTPUT

BLUE/BLACK L3 -300mA OUTPUT

WHITE PARKING LIGHT INPUT

YELLOW/BLACK IGN3 -300mA OUTPUT

BLUE L1 -300mA OUTPUT

WHITE LAMP OUTPUT

YELLOW/GREEN TRUNK OUTPUT

GREEN/BLACK L4 -300mA OUTPUT

PURPLE/BLACK L5 -300mA OUTPUT

RED/BLACK L6 -300mA OUTPUT

BROWN SIREN

RED +12V

ORANGE ARMING

H2-1 Green/black wire – (-) 300mA Channel 4 Output –

Same function as H2-2. This feature allows you to remote other electric device.