User's Manual

In Commercial Confidence
3
IV. BASIC FUNCTIONS
FUNCTIONS APPLICATIONS
GPS
GPS receiver will output a complete position, velocity, and time (PVT) solution in the NMEA
Version 3.0 protocol
GPRS, SMS
GPRS use standard TCP or UDP communicate protocol. If the GPRS service is failed, the SMS
mode will be turned on for emergency use.
5 input
1. Door TG-
2. general AD1 port
3. TG+
4. Tamper switch
5. TL sensor
PC-setup
Initialize the unit and program the device, including Network APN, server IP address, user
message, report control, and Geofence setting, etc …
Standard Report
Automatic report for AVL tracking purpose:
Fixed time report
Fixed distance report
Intelligent report (combine time and distance)
Self-diagnostic report
Event Report
Speeding report
Low battery report
Power cut report
Geofence report
TG+ on/off
AD1 trigger, e.g., …
History data store 900 reports can be saved in unit, and read from server and pc-setup
V. PANEL INSTALLATION AND WIRING DIAGRAM
Reset Button
Power/ ID learn
GPS
GPRS
Warning! Power off the system until the Red LED completely turns off before unplug or insert the SIM card. Otherwise, it
may damage your SIM card.
VI. WIRED PERIPHERAL TRIGGER
TLU100N system has 5 important peripheral trigger sources and an A/D input interface for potential usage.
1. TG+: It will send out a event report when TG+ on or off
2. Door TG-: It will send out an event report door open or close.
3. TL sensor: In sleep mode TLU100N will wake up the unit and send out an alert report.