User's Manual

In Commercial Confidence
11
2) Base on report mode
Parameters: Max. reconnect times, reconnect interval
While using this mode, the unit will connect to the server when there is a report to send. If the first connection is failed, it
will retry to connect to the server up to the max. reconnect times. Each retry will be separated by the reconnect “interval”.
3) GPRS connect once
While using this mode, the unit will connect to the server when there is a report to send (but only try once). If it is not
successful, the report will be stored and sent out in the next successful connection. Disconnect GPRS connection when
report sending is completed.
Reduce GPRS dialup method
Parameters: On/Off, Max. reconnect times, connect delay
If this method is used, the unit will reduce the GPRS dial-up connection when the dial-up is failed after number of times.
User can define the delay time for the unit before try to reconnect to the server. If there is trigger report, the unit will
connect to server immediately.
Special command for SMS mode:
If the TLU100N is not in the GPRS online status, user can send command &&Y02 or &&Y04 to ask unit to connect to
server. This command can be sent from any device via SMS;
&&Y02:
When received this command, system will actively try to connect to server in next 600 seconds.
&&Y04,[connection time],[report interval]:
For example: &&Y04,3600,60
When received this command, system will connect to server in the next 3600 seconds, and send one report out every
60 seconds.
(6) Self-diagnostic report (for a contain period of time, the UNIT can send a report to the server in order to check the
functionality)
Parameters: On/Off, and time.
4. [Trigger report and sleep mode setup]