User's Manual

In Commercial Confidence

In normal working mode (DUTY ON), the system will use the configurations as defined in this section. To activate the

automatic report, please select “√” in checkbox and fill in data in the textbox.

The reports will be summarized as

(1) Intelligent report

Parameters: On/Off, Report time when moving, Report time when stop, and threshold speed. Report when speed less than

a preset value (refer the following 1.5 Km/Hr), and it will send stop report after a preset time (refer the following 120Sec).

(min. speed is 0.1 km/Hr, max. speed is 1000 km/Hr).

(2) Intelligent history report (record the report in the system’s flash ram)

Parameters: On/Off, Report time when moving, Report time when stop, and Moving distance. (min. distance is 0.1 km,

max. distance is 1000 km).Note that: these report will not be sent out but only be saved in flash memory.

(3) AD detect report (AD1)

[on/off] SEND REPORT IF ADC1 LESS THAN [min voltage] V for [debounce time] SEC, RESEND PER [resend time]

SEC

[on/off] SEND REPORT IF ADC1 MORE THAN [max voltage] V for [debounce time] SEC, RESEND PER [resend time]

SEC

[on/off] SEND REPORT IF ADC1 GO UP [up voltage] V for [debounce time] SEC