User's Manual

J2-13.CHANNEL 4-OUTPUT MODE SELECT

Pre-set: Momentary output: Anytime, within 3 seconds press button 4 once then press

button 4, CH4 will output -300 Ma.

Variable1: Latched output: this selection will output a –300mA signal from the channel 4

output as soon as the channel 4 button is pressed and will continue until the button is

pressed again.

Variable2: Latched output/reset with ignition ON: this selection will output a –300mA

signal from the channel 4 output as soon as the channel 4 button is pressed but will reset or

stop when the ignition is turned ON.

Variable3: 30 seconds output: this selection will continue output a 30 seconds –300mA

signal from the channel 4 output as soon as the channel 4 button is pressed.

J2-14. DEFAULT SETTING

Pre-set: Return the feature menu 2 to the factory set-up.

FEATURE MENU 3 EXPLANATION:

J3-1. VEHICLE MODE

Pre-set: Automatic gear car: Without ‘ready mode’, remote start directly

Variable1: Manual gear car: The ‘ready mode’ routine has been completed successfully

system can remote start

J3-2. MANUAL GEAR CAR RESERVATION SETTING MODE

Pre-set: Manual setting: When the engine running, press button 3+4 once to routine ‘ready

mode’

Variable1: Auto pre-set setting: When the engine running exceed 10 seconds, ignition OFF

will automatically routine ‘ready mode’