User's Manual

17
FUNCTION SELECTION
a. The function selection is programmable. Please follow the procedure.
b. In disarming status, turn ignition on (must 5 seconds longer after last ignition off).
c. Within 8 seconds, press valet switch 3 times, then press once again and hold it for 3
seconds. System will chirp once to indicate entering function menu 1 selection, if
not releasing the valet switch and hold on for 6 seconds, system will chirp twice to
indicate entering function menu 2 selection, if still hold on for 9 seconds, system
will chirp three times to indicate entering function menu 3 selection.
d. After entering manuals, presses Valet Switch to select the function to be changed
within 20 seconds, system will chirp each time when Valet Switch is pressed and
released.
e. When reach the times of selected function, press button 1 once or button 2 once or
button 3 once or hold button 4 for 2 seconds (or press button 2 once to select
variable value 1, press button 2 once again to select variable value 2, press button 2
once again to select variable value 3) of the remote control to select. The siren will
chirp once when button 1 confirms the factory value, the siren will chirp twice when
button 2 is the optional variable value 2. The siren will chirp three times when
button 3 confirms the optional variable value 3, the siren will chirp four times when
button 4 for 2 seconds confirms the optional variable value 4.
f. When exceed 20 seconds or turn ignition off, system will have a long beep and leave
function selection mode.
FEATURE MENU 1:
Function selection
Pre set value
(1 chirp)
Variable 1
set-up
(2 chirps)
Variable 2
set-up
(3 chirps)
Variable 3
set-up
(4 chirps)
J1-1
Lock/unlock timer
0.5 seconds
3.5 seconds
J1-2
Lock time
Same as J1
15 seconds
30 seconds
J1-3
Unlock pulse
1 pulse
2 pulse
J1-4
Arm/disarm with chirp
On
Off
J1-5
Arming delay time
3 seconds
30 seconds
J1-6
Last door arming
On, without
lock
Off
On with
lock
J1-7
Auto re-arm
On, without
lock
Off
On with
lock