User's Manual

EMOTE ENGINE START FUNCTION DESCRIPTION

RPM

LEARNING (SEE FUNCTION SELECTION J3-4)

a. When the system is disarming and ignition ON, press valet switch 6 times within 10

seconds, the parking lights will flash twice to indicate that system has entered the

RPM learning mode.

b. Start the engine, when the RPM level is stabilized, press and hold valet switch till the

parking lights will flash twice and the siren will chirp twice, which indicates the

RPM value has been memorized successfully.

NOTE: The unit remote start defaults check mode is Voltage mode; before the system entry

the RPM learning mode, user must connect the vehicle RPM wire to the unit and function

selection must select the start check mode is RPM mode.

URBO MODE (SEE FUNCTION SELECTION J3-11)

a. The turbo mode is used for protect the engine.

b. Before the ignition is turned from ON to OFF (ignition must be ON more than 10

seconds), the engine will not shutdown immediately, but continue remain running for

3 minutes.

c. The engine will stop running immediately if step foot brake or release hand brake.

Reservation procedure for manual gear car (See Function Selection J3-1, J3-2)

a. If the car is the manual gear car, the unit must to perform the reservation procedure

before the remote engine start, the reservation procedure has two setting mode

selection.

b. The manual setting mode operation is following:

c. When the engine running, before you turn ignition OFF to stop the engine, pulls up

the hand brake, release the foot brake.

d. Gear keeps in Empty position.

e. Press button 3+4 once together.

f. Turn ignition OFF, the engine will still remain running for 2 minutes. Within 2

minutes, open and close the door, the parking light will flash twice indicate that the

reservation procedure is successful.