User Manual

6
IRKP-20 is an external wireless 20- key keypad to used for calling. Anytime the unit can call out and pick
up phone call as well. There are two ways to call out: 1) to dial the number directly through the keypad; 2)
press shortcut key to call the preset telephone number defined by PC setup software.
a. After dialing the telephone number, press button
once or button〝Ⅰ〞of two button valet
switch once dial out. If the dialing is successful, HAND FREE will ring, each time the button is
pressed, the HANDFREE will chirp once as indication. Once the dialogist picks up the phone, the
user can start talk with that person. Press button
once or button〝Ⅱ〞of two button valet
switch once will hang up the phone call.
b. If phone call comes in, HANDFREE will ring. User can either press button
once or button
〝Ⅰ〞of two button valet switch once to pick up the phone or press button
once or button
〝Ⅱ〞of two button valet switch once to hang up.
c. On the above operation, the interval between pressing each two buttons must be finished within 5
seconds, otherwise the unit will exit current mode automatically. If phone number is entered
incorrect, user can press button once clear all the input, and then user needs to restart
entering.
d. The unit has speed dialing function, it can preset four telephone number defined by PC setup
software. The button
, , , is indicate speed dialing key.
e. The unit has speed-dialing button
of change with SIM card, the speed dialing number can
preset by PC setup software.
IV. Valet switch OPERATION
(1) Sending help report
Press the button once, The LED will flash once and a help report will be generated and the system will enter
the monitor mode
(2) Activate or deactivate Immediate Geofence
Press the button and release it when the LED flashes once. After releasing it, the LED will stay continuously
on to indicate the ‘Immediate Geofence’ is on. To deactivate: Press the button (the LED will be temporally
off), and release it when the LED flashes once. After releasing it, the LED will then stay continuously off. A
report will be sent out if the vehicle goes out/in to the Geofence zone.
(3) Activate/Deactivate panic mode and send ‘panic’ report
Press the button (the LED will be temporally stay off) and release it when the LED flashes twice. After
releasing it, the panic mode is been triggered and the panic report is sent out. In panic mode, the horn will
sound and the parking light will flash. To exit panic mode: press the button (the LED will be temporally stay
off), and release it when the LED flashes twice. After releasing it, the horn and parking light will stop.