User Manual

4
GT3200 Can go to sleep mode when ACC goes off, Shock-sensor not be trigger for 5minuts and this feature
is configurable. “GPS” can be power off. User can setup the automatically wakeup time during the sleep
mode to ensure the device is working. The system can send out a diagnostic report to the server after waking
up.
During the sleep mode, if any of the inputs are triggered, the system will wake up and send relevant reports
to the server. The input triggers for waking the device up are selectable. When ACC is on, the system will
back to working mode and stay connected to the TCP/UDP server in GPRS network.
1.15 2-STAGE SHOCK SENSOR (Optional)
If car is lightly vibrated, siren will sound five times and parking light will flash five times to warn. If car
receives a heavy shock, siren will sound and parking light will flash for 30 seconds.
1.16 Monitor mode
There is two way enter the monitor mode: 1. Password way, you sent the password of preset in PC-setup by
SMS, if the password is right, then you will receive the PASS message, and system will enter the monitor
mode; 2. Valet switch way, if you press Valet switch once within one second anytime, then system will enter
the monitor mode. After the system enter the monitor mode, unit will auto answer the phone in the following
10 minutes. The system will auto exit monitor mode after 10 minutes.
II. BASIC FUNCTIONS
FUNCTIONS APPLICATIONS
GPS
GPS receiver will output a complete position, velocity, and time (PVT) solution in the
NMEA Version 3.0 protocol
GPRS, SMS
GPRS use standard TCP or UDP communicate protocol. If the GPRS service is failed,
the SMS mode will be turned on for emergency use.
9 input
In-vehicle Door -
In-vehicle door +
In-vehicle ACC
Temperature sensor /AD port (Optional)
Shock-sensor port
Crash sensor port
Valet switch port
Wireless 20- key keypad
RF-receive port (Optional)
8 output
1. Parking light
2. Door Lock
3. Door Unlock
4. ARM
5. Horn
6. Audio port (microphone and hand free)
7. Handset port (Optional)
8. Trunk output