User Manual

Parameters: resend interval, threshold speed, over speed delay time, exit over speed delay time, alert when

over speed and report send or ignore

For example, if resend interval is 20 sec, enter over speed delay time is 20 sec, threshold speed is 110Km/h

and exit over speed delay time is 2 sec.

If vehicle speed over threshold speed 20seconds, system will send speed over report once interval 20 sec

until exit speed over delay time 2 sec, the over speed report will stop to send. If alert when over speed has

configured, then it will alert when speed over.

(12) Crash report

Parameters: on/off, and speed

You can select the crash report to be sent or not, while crash sensor over a preset value.(The crash sensor

must be fit up, or the report still be ignored even if you select the item.) Otherwise the report will be ignored.

(13) Tilt report

Parameters: on/off, and degree

If ACC off, then crash-sensor will work (if the Tangent angle sensor connected). crash-sensor can detect the

little angle change. If the car be shake, then the crash-sensor will be triggered. And crash-sensor will wake

up the system.

(14) GPRS dial-up procedure

1) GPRS always online

Parameters: Reconnect interval

While using this mode, when the unit can not searched GPRS signal, system will reconnect GPRS interval a

preset value. (e.g.: 1minute)

2) Based on report mode

Parameters: Max. reconnect times, reconnect interval

While using this mode, the unit will connect to the server when there is a report to send. If the first

connection is failed, it will retry to connect to the server up to the max. reconnect times. Each retry will be

separated by the reconnect “interval”.