User Manual

16
[on/off] SEND REPORT IF ADC2 LESS THAN [min voltage] V for [debounce time] SEC, RESEND PER
[resend time] SEC
[on/off] SEND REPORT IF ADC2 MORE THAN [max voltage] V for [debounce time] SEC, RESEND PER
[resend time] SEC
[on/off] SEND REPORT IF ADC2 GO UP [up voltage] V for [debounce time] SEC
[on/off] SEND REPORT IF ADC2 GO DOWN [down voltage] V for [debounce time] SEC
[on/off] SEND REPORT IF ADC2 ENTER/EXIT [min voltage] V TO [max voltage] V for [debounce time]
SEC
Note: AD2 input voltage range is 0~3.30v, it must connect a resistance to share the voltage if the detected
voltage higher than 3.30v.
(7) Fixed time report
Parameters: On/Off, and time.
(8) Fixed distance report
Parameters: On/Off, and distance. (min. distance is 0.1 km, max. distance is 100 km).
(9) Course change report (to send a report when the course change is bigger than the value set here)
Parameters: On/Off, course change in degree and debounce time.
(10) Low battery warning report (to alert user when the external battery level is low)
Parameters: On/Off, and warning battery level for report. For example, 50 to represent 50% lower level
report.
The system will ignore the parameter with a value ‘0’ to prevent continuous non-stop reporting.
(11) Speed report