User Manual

(3) IO connect selection

Parameters: to select either temperature sensor or AD1

(4) Temperature report

Parameters: On/Off, and min. and max. temperature.

(5) AD detect report (AD1)

[on/off] SEND REPORT IF ADC1 LESS THAN [min voltage] V for [debounce time] SEC, RESEND PER

[resend time] SEC

[on/off] SEND REPORT IF ADC1 MORE THAN [max voltage] V for [debounce time] SEC, RESEND PER

[resend time] SEC

[on/off] SEND REPORT IF ADC1 GO UP [up voltage] V for [debounce time] SEC

[on/off] SEND REPORT IF ADC1 GO DOWN [down voltage] V for [debounce time] SEC

[on/off] SEND REPORT IF ADC1 ENTER/EXIT [min voltage] V TO [max voltage] V for [debounce time]

SEC

Note: AD1 input voltage range is 0~3.30v, it must connect a resistance to share the voltage if the detected

voltage higher than 3.30v.

(6) AD detect report (AD2)