User's Manual

3
1.7 Valet switch operation
User can use the supplied Valet switch to perform 5 essential tasks, including (1) sending help report (2)
activate or deactivate Immediate Geo-fence (3) sending ‘Duty on’ or ‘Duty off’ report to the server (4)
Emergency release to exit ‘ARM’, ‘Anti-carjacking’ or ‘Panic’ modes
(1) Sending ‘HELP’ report
Press the button once, The LED will flash once and a ‘HELP’ report will be generated.
(2) Activate or deactivate Immediate Geo-fence
Press the button and release it when the LED flashes once. After releasing it, the LED will stay continuously on
to indicate the ‘Immediate Geo-fence’ is on. To deactivate: Press the button (the LED will be temporally off),
and release it when the LED flashes once. After releasing it, the LED will then stay continuously off. A report
will be sent out if the vehicle goes out/in to the Geo-fence zone.
(3) Panic
Press the button (the LED will be temporally stay off) and release it when the LED flashes twice. After
releasing it, a panic action will be generated.
(4) ‘Duty on’ or ‘Duty off’ reports / ‘Status on’ Status off’ reports
Press the button (the LED will be temporally stay off) and release it when the LED flashes 3 times. After
releasing it, a ‘Duty on’ report will be sent out. To deactivate: Press the button (the LED will be temporally stay
off) and release it when the LED flashes 3 times. After releasing it, a ‘Duty off’ report will be sent out.
(5) Emergency release to exit ‘ARM’, ‘Anti-carjacking’ modes.
ACC ON, press and hold the button (the LED will be temporally stay off) and release it when the LED flashes 5
times. After releasing it, ‘ARM’, ‘parking light’, and ‘siren’ outputs will back to normal (Disarm) status.
1.8 History report
Flash memory for recording reports up to 900 reports. It can be read out from the PC setup program via serial
port.
1.9 Backup battery (optional)
The system has a built-in rechargeable battery (4.8V 20mA/H) for emergency use. The system will send a
power cut report when all the external power is disconnected.
1.10 LED indication
Three LED indicate the status of the POWER, GPRS signal and GPS signal.
1.11 Keep alive procedure
Keep alive procedure (in order keep connection in GPRS network, the unit can be set to send short keep alive
report to the server in order to prevent the disconnection from the mobile service provider)