User's Manual

1.3 Geo-fence function

The device has built-in 30 Geo-fence sets (1 immediate Geo-fence, 4 circular, 5 rectangular and 20 point); it

will send the report to the server if the Geo-fence event is triggered. User can setup the Geo-fence area from the

PC setup program or sending the defined.

A unique immediate Geo-fence function:

‘Immediate-Geo-fence function’ is a circular type Geo-fence that can be activated or deactivated from a single

button. When activated, the system will record the current position and use the pre-defined radius as a circular

Geo-fence to guard the vehicle. If the vehicle moves out of the preset Geo-fence zone, a report will be

generated to the server. User can deactivate the self-Geo-fence at any time by pressing the valet switch again. If

the GPS cannot be located when the Immediate Geo-fence function is been executed, GT3100 will use the last

known position as the origin of the circular Geo-fence zone to perform the protection.

US Patten for immediate Geo-fence function is pending.

1.4 Store and forward ability

When there is no GPRS service or the server close. The unit will send short message to the server if defined

SMS number. All the stored report will be forward to the server when GPRS connection is completed next time.

1.5 TCP and UDP socket support

GT3100 supports both UDP and TCP socket communication. The server IP, port number and socket type can

be selected from the PC-setup program or remote server command. In addition, the connection can be swap

over to any server IP or port (either UDP or TCP) via the air command.

1.6 The server can send the command to control the device and the build in alarm.

Command for in-vehicle control:

We design 8 commands that can be integrated into the server, so that the users can control their vehicles. Those

commands are: (1) Door lock, (2) Door unlock, (3) Arming, (4) Panic, (5) Enable anti-car jacking, (6)

Emergency release, (7) Trunk release, (8) Channel 2 outputs.

Notes:

1. Arming (this command is valid only if when ACC is off): If ACC Off, Server send arming command. The

door will lock and the Engine will be Disable starter (if the starter cut relay connected), after the unit

received the command.

2. Panic: (can be performed at any time) If Server send panic command, the horn will sound and parking

lights will flash for 30 seconds after the unit received the command.

3. Enable anti-car jacking: (can be performed at any time) If Server sends anti-car jacking command, the

system will enter anti-carjacking mode after the unit received the command. When the anti-carjacking has

activated, from the beginning to 30 seconds, the LED will flash once and siren chirp once interval 10

seconds, from 31 to 60 seconds, the LED will flash once and siren chirp once interval 5 seconds, from 61

to 120 seconds, the LED will flash once and siren chirp once interval 1 seconds, after 120 seconds, system

will locked ignition and LED will flash once and siren will chirp once interval 1 seconds. To release anti

carjacking: To send emergency commands or ACC ON, press emergency button to release anti carjacking.

4. Emergency release: (can be performed at any time) If Server send Emergency release command while at

Arming mode, panic mode, anti-car jacking mode. Then system will exit ‘Arming’, ‘Anti-carjacking’,

‘Panic’ mode. The ‘Arming’, ‘parking light’ and ‘siren’ outputs will back to normal (Disarm) status.