User's Manual
1
GT2000NP REV 3.1 (GT2000NP gt2k4-d-ptm-5.5.2-2.03.enc gt2000np-d3)
I. BRIEF INTRODUCTION
Personal Tracking System utilizes the GPS and GPRS functions in one unit. You can monitor the vehicle or the
people location and set the system remotely. In addition, the unit will send event report if any trigger occurs.
The standard report sent by the unit includes the information: (1) unit’s ID, (2) status, (3) time, (4) GPS’s
latitude and longitude, (5) speed, (6) direction, (7) device’s status, (8) event number, and (9) report
configuration parameters.
The reporting mode can be categorized as ‘normal’ mode, and ‘power saving’ mode. In normal mode, the GPS
will always be activated while moving, and it can be shut off the GPS when stop (for power saving purpose). To
enable the maximum power saving, user can choose “power saving mode”. In this mode, the GPS will be
activated only when there is a report to send while moving. The report parameters can be set from the PC setup
program. GT2000NP/GT2500NP can be set to go in sleep mode (while not moving), the system will cut the
power of GPS module in order to save power. With build-in 3-D acceleration sensor, GT2000NP/GT2500NP
can select related reporting modes with respect to it is moving or not.
The device has built-in 4 Geo-fences and one immediate Geo-fence (in circular shapes), it will send the report
to the server if the Geofence event is triggered.
The UNIT must be initialized by PC setup program in order to make communication with the remote server
/call center. There are three main sections that allow users to program the device, (1) User detail (Device ID,
server IP, and port, GPRS APN….) (2) Geo-fence (5 circular Geo-fence) (3) Report (Time, Distance, speed,
Low battery, wakeup …)
A unique help report: user can press the Button 3 for 2 seconds after the unit power on. The unit will send the
help report to server, power LED flash 5 times at the same time.
Taxi mode on/off: Pressing “II” twice within 2 seconds will put the unit into “Taxi mode”. Pressing “II” twice
again within 2 seconds will take the unit out of “Taxi mode”. When the unit enters “Taxi mode”, the top LED
will flash 3 times/3sec and unit will vibrate once every minute. When in Taxi mode, the unit will automatically
vibrate every one minute. When the unit vibrates at these intervals, the user must press “II” within one minute
each time, if not, the unit will automatically send an “SOS” report to the server.
When there is no GPRS service or the server close. The unit will send short message to the preset number. The
max number of SMS message (monthly usage) and the monthly renew date can be set from the pc setup
program or the remote setup program. Only 1 SMS number can be set. The reports sent via the SMS will be out
again via GPRS after a valid GPRS connection is made.
GT2000NP/GT2500NP can be configured by the PC setup program or the Over-the-Air (OTA) commands / or
remote program. The unit can communicate with the server via UDP or TCP protocol. The protocol can be
selected from the PC-setup program or remote server commands.