User's Manual

IO Connection

Four Button One Power button,

3 speed dialing buttons

1 volume adjust button

Communication

GPRS \SMS\RS232\

Environmental

Operating Temperature -20°C to +55°C

Storage Temperature -40°C to +85°C

Accessories

1. Internal battery

2. PC setup cable

Additional:

1. GPS indicator (bottom LED): LED is GREEN when the unit has acquired a valid GPS signal, and it will

flash when the unit is searching GPS signal.

2. If dialing out to a number fails, the unit will chirp twice.

3. If there is a GPS signal when an “SOS” report is sent, the unit will vibrate once. If there is no GPS signal

when an “SOS” report is sent, the unit will vibrate twice.

4. When dialing out, the unit will chirp once*

5. When a self-geofence is set, the unit will chirp twice*

6. When a “help” report is sent, the unit will chirp three times*

7. Taxi mode on/off: Pressing “II” twice within 2 seconds will put the unit into “Taxi mode”. Pressing “II”

twice again within 2 seconds will take the unit out of “Taxi mode”. When the unit enters “Taxi mode”,

the top LED will flash 3 times/3sec and unit will vibrate once every minute. When in Taxi mode, the unit

will automatically vibrate every one minute. When the unit vibrates at these intervals, the user must press

“II” within one minute each time, if not, the unit will automatically send an “SOS” report to the server.

* The chirping acknowledgement sounds can be switched ON and OFF as desired. To switch chirping ON,

press and hold “▼” for 2 seconds (it will chirp once to acknowledge that chirping is on). To switch chirping

OFF, press and hold “▼” for 2 seconds (it will chirp twice to acknowledge that chirping is off).

VI Federal Communications Commission (FCC) Statement

6-1

You are cautioned that changes or modifications not expressly approved by the part responsible for

compliance could void the user’s authority to operate the equipment.