User's Manual

(4) GPS wakeup report:

While the device is in stop status, user can let the GPS go to sleep mode for power saving. If select GPS sleep

ON, user can setup the wakeup report configuration/ or NO GPS wakeup report.

IF select GPS SLEEP OFF, CTS-100 will follow the report sending rule in “When Moving” section.

Power saving mode

While in Power saving mode, CTS-100 will cut off the GPS power if there is no report to send.

Report configuration will be listed as: the fixed time report while moving, and wakeup report / or no GPS

wakeup report while stop. In this mode, in order to save power unit will cut power of GPS, only wake up GPS

at the time of send report.

GPRS dial-up procedure

1) GPRS always one-line

Parameters: Reconnect interval

While using this mode, when the unit can not searched GPRS signal, system will reconnect GPRS interval a

preset value. (e.g.: 1minute)