Installation Guide

ASSEMBLY INSTRUCTIONS

Outlet Box

Washer

Remove decorative nuts (C) from front of fixture

(A) and remove mounting plate (B) from back of

fixture (A). Save decorative nuts (C) for later

use.

Hardware Used

Machine Screw

x 2

Feed supply wires through center of mounting plate

(B). Attach mounting plate (B) to outlet box (not

included) using the existing washers and outlet box

screws or the machine screws (BB). Note: If the

outlet box screws required for your outlet box are of

a different size than the machine screws (BB),

consult with a licensed electrician before

proceeding.

Use a level (not included) to adjust mounting plate

(B) as needed so preassembled screws (E) in

mounting plate (B) are parallel with floor and

ceiling, then tighten machine screws (BB)

completely to secure mounting plate (B).

CAUTION: Make sure the outlet box can

support 35 lbs. hanging weight. Use metal outlet

box; plastic outlet boxes are not recommended.

Washer