Installation Guide

6
ASSEMBLY INSTRUCTIONS
Remove two decorative nuts (C) from front
of fixture (A) and remove mounting strap (B)
from back of fixture (A).
4a.
4b.
Hardware Used
Machine Screw
x 2
BB
Attach mounting strap (B) to outlet box (not
included) using the existing washers and outlet
box screws or the machine screws (BB). Note: If
the outlet box screws required for your outlet
box are of a different size than the machine
screws (BB), consult with a licensed electrician
before proceeding.
Use a level (not included) to adjust mounting
strap (B) as needed so the screws (D) are
parallel with floor and ceiling, then tighten
machine screws (BB) completely to secure
mounting strap (B).
CAUTION: The fixture must be mounted to
an outlet box that is supported by the building
structure and can support the weight of the
fixture. Plastic outlet boxes are not
recommended.
4b
Outlet Box
D
B
BB
Washer
Washer
BB
4a
A
B
C
Adjust screws (D) to proper length by screwing
them completely into mounting strap (B).
Temporarily place fixture (A) over mounting strap
(B) to determine amount of adjustment
necessary for screws (D). NOTE: Screws (D)
should come through holes in fixture (A) just
enough so decorative nuts (C) fit flush against
fixture (A) when mounted. Once screws (D) are
adjusted, tighten nuts (E) securely against
mounting strap (B).
Set fixture (A) aside.
5.
C
Outlet Box
B
D
5
A
E