Installation Guide

4 5
A
C
D
B
CC
CC
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
2. With another person holding fixture plate (A) up to the
mounting surface so the wires align with the outlet box
(not included), mark the mounting holes of fixture plate
(A) with a pencil (not included). Set fixture plate (A)
aside.
WARNING: Two people are required for this step.
WARNING: Two people are required for this step.
Ensure the power is off before proceeding.
2
1. Open the diffuser latches (C) on fixture plate (A). Pull
and hold open the end caps (D) and remove diffuser
(B) from fixture plate (A). Set diffuser (B) aside until
later.
1
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time: 45 minutes (with two adults).
Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver, safety
glasses, hammer, pencil, pliers, step ladder, power drill and 1/8-in. drill bit or 5/32-in. drill bit.
PREPARATION
Wood Screw x 4
AA
3
3. DRYWALL MOUNTING: Use a 1/8 in. drill bit (not
included) at the 4 marked locations. Install drywall
anchors (BB) into the holes with a hammer (not
included). Install the wood screws (AA) into drywall
anchors (BB), leaving approximately 3/8 in. gap
between the screw head and the mounting surface.
WALL STUD MOUNTING: Use a 5/32 in. drill bit (not
included) at the 4 marked locations. Install wood
screws (AA) into the mounting surface, leaving
approximately 3/8 in. gap between the screw head
and the mounting surface.
Wall Stud
Pilot hole
BB
Drywall Mounting Wall Stud Mounting
Drywall
Hardware Used
Drywall Anchor x 4
BB
Hardware Used
Wire Nut x 3
Lowes.com/portfolio
Lowes.com/portfolio
outlet box
A
4. With another person holding fixture plate (A) up near
the outlet box, connect the supply wires to the fixture
wires --
black to black, white to white, and green to
copper/bare.
WARNING: If there is no ground supply wire, stop
installation and consult a qualified electrician.
Once wire connections are made, secure each with a
wire nut (AA) and tuck all wiring into the outlet box.
4
A