Installation Guide

4
ASSEMBLY INSTRUCTIONS
Hardware Used
BB
x 2
Outlet Box
Screw
1. Secure the crossbar assembly (A) to the outlet box
(not included) with outlet box screws (BB). Tighten
until snug.
Note: The preassembled mounting screws on the
crossbar should protrude outward.
Note: Prior to installation, close or cover the sink
drain and/or any vents near the installation site to
prevent loss of mounting hardware if dropped.
I
1
Outlet Box
A
BB
Lowes.com/portfolio
Outlet Box
Hex Nut
D
A
2
Mounting Screw
Mounting Ball
2. Remove mounting balls from mounting screws on
crossbar assembly (A). Temporarily fit fixture body
(D) over the mounting screws (A) and secure with
mounting balls.
Note: The backplate of the fixture body (D) should
be snug against the wall and the mounting balls. If
not, adjust the length of the mounting screws by
unscrewing the preassembled hex nut and then
screwing the mounting screw in or out of the
crossbar until the correct length is achieved. Then,
tightened the loosened center screw preassembled
on crossbar assembly (A) to lock the position of the
mounting screws.
Once the backplate of fixture body (D) is secure,
remove the mounting balls and fixture body (D) and
proceed to step 3.
Center Screw