Installation Guide

8. Fit shade (C) and shade holder (D) over the stem

and secure with the previously removed finial.

Note: The shade (C) and shade holder (D) should be

snug against the canopy (B) and the finial. If not,

adjust the length of the stem by unscrewing the

preassembled ring and then screwing the stem in or

out of the hex coupling until the correct length is

achieved.

Once the shade (C) and the shade holder (D) is

secure, remove the finial, the shade holder (D) and

the shade (C).

7. Thread the ring end of stem (E) onto the hex

coupling inside the fixture body (B). Hand tighten

until snug.

667

669

6610

6611

Hex Coupling

Stem

Ring

Stem

Hex Nut

Rubber Washer

Flat Washer

Finial

9. Install bulbs (F) into socket of fixture body (B).

668

Finial

ASSEMBLY INSTRUCTIONS

10. Place shade (C) and the previously removed rubber

washer and flat washer over the stem, securing with

the previously removed hex nut. Hand tighten until

snug.

11. Place the previously removed shadeholder (D) over

the stem extruding from the fixture body (B),

securing with the previously removed finial. Hand

tighten until snug.