Installation Guide

5
Flat Washer
Stem
Hex Nut
Finial
Rubber Washer
Flat Washer
ASSEMBLY INSTRUCTIONS
4
White Wire
From Outlet Box
Black Wire
From Outlet Box
Bare, or Green
Ground Wire
Bare, or Green
Fixture Ground Wire
From Outlet Box
Bare, or Green
Ground Wire
From Outlet Box
White or
Ribbed Side
From Fixture
From Fixture
Black or
Smooth Side
OR
AA
Hardware Used
AA
x 3
Wire
Connector
Green Ground Screw
4. Attach ground fixture wire to either the green ground
screws preassembled on the crossbar assembly (A)
or to the ground wire in the outlet box (usually
GREEN or BARE). If attaching fixture ground wire to
the crossbar assembly (A), it is imperative the outlet
box in your home be properly grounded. Connect the
neutral WHITE or RIBBED fixture wire to the neutral
(usually WHITE) wire from the outlet box. Connect
the hot BLACK or SMOOTH fixture wire to the hot
(usually BLACK) wire from the outlet box. Fasten
wires together with wire connectors (AA) and tightly
wrap wire connectors (AA) with electrical tape (not
included).
5. Pass center hole of fixture body (B) and the
previously removed flat washer and lock washer
over the nipple of crossbar assembly (A). Secure
by threading the previously removed hex
coupling onto the nipple. Tighten until the fixture
body (B) is flush against the ceiling.
665
B
E
Nipple
Hex Coupling
Lock Washer
6
6. Remove the finial, hex nut, flat washer and rubber
washer from the stem assembly (E). Save for later
use.