Installation Guide

x 2

Hardware Used

2. Secure the crossbar assembly (A) to the outlet

box (not included) with outlet box screws (BB).

Tighten until snug.

Note: The preassembled mounting nipple on the

crossbar should protrude outward.

Outlet

Box

Screw

Outlet Box

1. Remove the hex coupling, the flat washer and the

lock washer from the crossbar assembly (A). Save

for later use.

Hex Coupling

Lock Washer

Flat Washer

3. Fit fixture body (B) over the nipple on crossbar

assembly (A) and secure from inside with the

previously removed hex coupling.

Note: The fixture body (B) should be snug against

the ceiling and the hex coupling. If not, adjust the

length of the nipple on crossbar assembly (A) by

unscrewing the preassembled hex nut and lock

washer and then screwing the nipple in or out of the

crossbar until the correct length is achieved.

Once the ceiling canopy of fixture body (B) is secure,

remove the hex coupling and fixture body (B).

Lock Washer

Hex Nut

Nipple

Hex Coupling

663

ASSEMBLY INSTRUCTIONS