Installation Guide

4
ASSEMBLY INSTRUCTIONS
x 2
Hardware Used
1
1. Secure the crossbar assembly (A) to the outlet box
(not included) with outlet box screws (CC). Tighten
until snug.
Outlet Box
Screw
CC
CC
A
Outlet Box
B
Mounting Ball
Mounting
Screw
2. Remove mounting ball from crossbar assembly (A).
Fit fixture body (B) over the mounting screw on
crossbar assembly (A) and secure with mounting
ball. Note: The ceiling canopy of the fixture body (B)
should be snug against the ceiling and the mounting
ball. If not, adjust the length of the nipple on
crossbar assembly (A) by unscrewing the
preassembled hex nut and lock washer and then
screwing the mounting screw in or out of the
crossbar until the correct length is achieved.
Once the ceiling canopy of fixture body (B) is
secure, remove the mounting ball and fixture body
(B) and proceed to step 3.
Lowes.com/portfolio
AA
BB
3. Attach ground fixture wire to either the green
ground screw (AA) on crossbar (A) or to the
ground wire in the outlet box (usually GREEN
or BARE). If attaching fixture ground wire to
the crossbar (A), it is imperative the outlet
box in your home be properly grounded.
Connect the neutral WHITE or RIBBED side
fixture wire to the neutral usually WHITE wire
from the outlet box. Connect the hot BLACK
or SMOOTH side fixture wire to the hot
usually BLACK wire from the outlet box.
Fasten wires together with a wire
connector (BB) and tightly wrap wire connector
(BB) with electrical tape (not included).
3
White Wire
From Outlet Box
Black Wire
From Outlet Box
Bare, or Green
Ground Wire
Bare, or Green
Fixture Ground Wire
From Outlet Box
Bare, or Green
Ground Wire
From Outlet Box
White or
Ribbed Side
From Fixture
From Fixture
Black or
Smooth Side
OR
BB
AA
Hardware Used
x 1
Green
Ground
Screw
x 3
Wire
Connector
662
Hex Nut and
Lock Washer